Directions to Assemble the Windsor Laptop Stand

1.)Remove all items from box and lay flat on the floor. Keep all small pieces in their original packaging, but remove plastic from all large items.



2.)Place numbered item 18 [The Cross-like large piece] flat on the floor. Make sure screw holes are down facing the floor.



3.)Remove numbered items 5 and 6 [5-M6X30 screws (4 of them) and 6-M6 (4 of them)]. Remove numbered item 17 [17-X1 Large T-shape item].Stand numbered item 17 upright, and place on the midpoint of numbered item 18. Both pieces should be touching one another. Make sure the longer side of numbered item 17 is aligned with the longer side of numbered item 18. The two long sides should be parallel with one another.



4.)Remove numbered item 15 [X1 Small Wrench] from the bag and use to secure numbered items 5 and 6 in the four holes, thus connecting numbered items 17 and 18 together.



5.)After base is secure (items 17 and 18 are securely tightened together), remove numbered item 7 [MB-knob] and screw into the center hole of numbered item 17.



6.)Remove numbered items 14, 8 and 11[14-MB Washers (2 of them), 8-MB Small knobs (2 of them), and 11-Semi circles with flat surfaces]. Starting with item 11, place over the one of the ends of the rod on item 17 (it doesn’t matter which side you start with). Have the curved side of the semi circle face in. Remove item [1-Smaller side of the flat desk surface] and place on top of the shorter side of item 17. Lay flat with screws facing down. Remove item [16-L-shaped tool]. Remove items [3-Short Screws (4 of them) and 4-longer screws (4 of them].With the help of item 16, assist item 3 in screwing into item 11 in place. Place item 14 over item 8 and screw into the hole, thus connecting items 11 and 17. Repeat on the other side.





7.)Remove items 2 and 13 [12-U-shaped with flat surface and 13-Flat narrow piece with two holes] and place item 13 over the two holes of item 1, on the under side. Line up the holes. Place item 12 over the rod bar of item 17, and line up with item 13 and item 1. All holes should be lined up. Use item 4 to secure items 12 and 13 together. (Repeat the whole process on the other side with the other desk piece, item 2).



8.)Remove items [9-Stopper wheels and 10-Regular Wheels] and attach item 9 to the longer sides of item 18. Screw right in with hand. Screw item 10 into the shorter T-shaped side of item 18. Be sure that all screws are securely fastened and that all pieces are in tightly.



9.) Turn desk upright and prepare for use.